BEIJING GALLOP TECHNOLOGY CO.,LTD
Categories
Contact Us
Beijing Gallop Technology Co.,Ltd
Add:Room410 Tower C, Jiahua Buiding NO.9 Shangdi 3 Street Haidian District, Beijing
Tel:+86-010-51269778
Fax:+86-010-62967939
Mobile:+86-13858586115
E-mail:13858586115@163.com
Knowledge
Home > Knowledge > Content
Powder Radar Level Meter, Level Transmitter
May 09, 2018

Basic Info

Warranty: 1 Year

Material: SS304

Process Temperature: -40~250℃

Frequency Range: 26GHz

Application: Solid Particles, Powder

Precess Connection: Thread, Flange

Media Temperature: -40 to 250 C (-40 to 482 F)

Process Pressure: -0.1to 4 MPa

Protection: IP 67

Explosion-Proof: Exia Iic T6 Ga

Signal Output: 4....20mA/Hart (Two-Wire / Four), RS485/Modbus

Transport Package: Carton

HS Code: 9026100000

Product Description

Powder Radar Level Meter, Level Transmitter
Powder Radar Level Meter are 26G HF radar level meter, the maximum measuring distance of which reaches 70 meters.The antenna can be further optimized and the new-type microprocessor can process signal analysis of higher speed. So the meter can be used for: complicated measuring conditions of reaction still and solid material stock bin.

Characteristics

--Transmitting frequency as high as 26GHz

--Non-contacting radar, no abrasion and contamination

--Small sized antenna for easy installation

--Shorter wave length, better reflection achieved on inclined solid surface

--Smaller dead zone, better results ensured even in cannikin measurement

--Small beam angle and concentrated energy to avoid interferences

--Hardly influenced by corrosion and foam

--Hardly influenced by changes of steam vapor, temperature and pressure

--Hardly impacted by heavy dust

--High SNR to ensure performance even under fluctuation

--Choice for solid media and media with low dielectric constant
 

Operating Principle
Powder Radar Level Meter antenna transmits narrow microwave pulse, which is top-down transmitted through antenna. The microwave is reflected after contacting the surface of measured medium and the signal is received by antenna system, then the part transmitted to electronic circuit is converted into material level signal automatically. (Because the microwave transmission is extremely rapid, so the round-trip time between the objective and the receiver is almost instantaneous.)
Note: Make sure that the highest material level does not enter into measurement dead zone when using the radar level meter. (As indicated Zone D in the figure).


 

  • Newsletter
  • Categories
  • Contact Us
    Beijing Gallop Technology Co.,Ltd
    Add:Room410 Tower C, Jiahua Buiding NO.9 Shangdi 3 Street Haidian District, Beijing
    Tel:+86-010-51269778
    Fax:+86-010-62967939
    Mobile:+86-13858586115
    E-mail:13858586115@163.com
  • QR Code
  • Copyright © Beijing Gallop Technology Co.,Ltd All Rights Reserved.