Put the Display Where Operators Can Reach It Split Type Ultrasonic Level Transmitter is designed for tanks, channels and wells where the sensing point is remote from a safe or convenient operator location. A compact transmitter may place the display over a hot tank, high platform or flood-prone chamber, making setup and service difficult. A split design keeps the ultrasonic transducer at the measurement point while relocating the controller for safer viewing, wiring and adjustment. Separate the Sensor From Heat, Flooding or Vibration The transmitter sends an ultrasonic pulse toward the surface and converts the return time into distance and level. Non-contact measurement keeps the sensor away from wastewater, chemicals and moving equipment, while local display and signal outputs support continuous control. Gallop lists compact and split structures, 0.4 to 20 m measuring ranges, ±0.5 percent full-scale accuracy, 4-20 mA, RS485 and HART options, and IP68 sensor protection for the core GLP-7 series. Optional relay output can support pump start and stop logic. Gallop lists a maximum transducer-to-transmitter distance of 100 m for the open-channel series; the exact level-transmitter limit must be confirmed for the selected model. This page can naturally support buyer terms such as non-contact level transmitter, ultrasonic tank level sensor, 4-20 mA level measurement, pump control and remote level monitoring. Engineer Cable Length and Signal Integrity Define cable route, shielding, conduit, junctions, lightning exposure, mounting height and dead zone, and avoid unauthorized cable extensions. Locate power, relays and communication wiring in the accessible controller area, and preserve diagnostic access so field teams can distinguish a weak echo from a wiring problem. Dense foam, heavy vapor, vacuum, strong turbulence, internal obstructions and material buildup can weaken or misdirect the echo. A clear sound path and sufficient blanking distance are required. Gallop shows magnetic-flow calibration and professional gas-calibration equipment in its factory material. Procurement teams should request the model-specific factory test report, serial traceability and final configuration sheet with the quotation.